TPE Furniture Leg Floor Protectors (Round, 16-Pack)

Product detail

Round floor protectors that slip over chair and table legs to stop scraping, scratching and dragging noise on hard flooring. The body is a soft TPE rubber shell with a felt pad bonded inside it, so the leg lands on felt rather than on the floor, and the shell wraps the leg by 30 mm with a 4 mm wall over a 10 mm felt layer. Gripping ribs inside and a tightened opening at the top hold the protector on the leg when the chair is dragged, which is the point where plain stick-on felt pads usually come off. A sixteen-piece pack in transparent covers legs with a diameter of 15 to 20 mm, and fitting takes no tools: push the leg into the shell and it locks. Suited to dining chairs, stools, desks and display units in homes, dormitories, restaurants and offices. The shells rinse clean and can be moved to another set of furniture. Because the shells can be pulled off and refitted when a room is rearranged, a venue avoids throwing away floor protection every time furniture changes. Stockists can display the pack as a fit-and-forget accessory beside the castors and glides, giving buyers a single source for chair maintenance. Chairs and table legs scratch a floor within a season, so venues and offices fit protectors with a felt base; the TPE sleeve grips the leg without adhesive and stretches over the sizes a buyer already stocks. Because there is no adhesive to go stale, a protector can be pulled off, rinsed and pushed onto another chair when a room is re-laid out, so a venue does not buy floor protection twice for the same floor. The felt layer is bonded inside the shell rather than stuck to the face, so it cannot peel away and leave a bare leg dragging on the flooring once the glue has aged.