Pneumatic Filter-Regulator-Lubricator Unit AFC2000 (1/4 inch)

Product detail

Two-piece air preparation unit that fits between the compressor and the tool. The filter-regulator half drops water and particulate out of the air supply through a 40 um copper filter element and then holds the outlet at a steady set pressure, with a round gauge on the front showing the setting and a manual drain under the bowl; the lubricator half adds a fine oil mist so air motors, cylinders and impact tools stay lubricated in service. The pressure range is 0.05 to 1 MPa, and the inlet and outlet ports are both 1/4 inch, so the unit drops into a standard workshop line without adapters. The bowls are clear so water and oil levels can be seen without breaking the line. Suited to spray booths, automation rigs and general air tool installations. Service technicians check the bowl during a plant walk-round, topping up the oil before a long spray session starts on the line. A common add-on when a workshop buys its first air tools, since contaminated air is the usual reason a tool runs rough after a few months. Mounted at the wall rather than at the tool, it gives every drop downstream one shared pressure setting, so two operators running the same tool see the same performance from it. The bowls are reached from the front of the assembly, so a drain or a top-up is done without breaking the line apart.